Metra thermal evaporator off line due to pump failure.
For those using the Cl and F Oxford etchers, if you are cleaning/conditioning the chamber before your actual sample, you may remove up to 30 minutes of your reservation after your session. It is expected for the users to modify it within 8hrs of when the reservation started. Failure to do so will result in standard charge rate for those times. Staff will NOT change this after the modification window.
The BET system is not operating properly. A service has been unsuccessful. We are waiting to hear when a more comprehensive service can be performed.
Beneq ALD TMA precursor was refilled with limited amount. More is one the way. Notify the staff if you notice low/no pulses. Once additional TMA arrives, the tool will be taken offline again for short period of time. If you notice the reactor pressure greater than 5 mbar, notify the staff immediately.
New rates and target limitations are established for AJA ATC Orion 8 Sputtering system. See scheduler reservations for details.
If you run a process that has variable rates (i.e.- ALD, furnace, sputter, etc.), make sure you write in the final dollar amount in the Description of Operation section of your reservation along with the reservation ID number of the original run. Otherwise you will be charged for the full rates.
External Materials If you plan to bring external materials into the lab, please notify the FabLab staff to ensure proper safety protocols and any equipment arrangements can be made. Please submit an External Materials Request form for each material you will bring. This form can be found on the Fablab equipment page.
The NanoCenter and FabLab need your help! Acknowledging the support given by the NanoCenter in your presentations and publications help us out tremendously.
Current hours are:
7:00am - 5:00pm
Monday - Friday
The Main FabLab is open 24/7 with restricted after hours access between 8:00pm - 7:00am.